1.0.1
The Generalist
Average print time: 4 hours
- Resin Printer ready
- Pre-supported
- No glue needed
About this model
Changelog
1.0.1 (September 10, 2021)
Some 10x3mm magnets where removed from the wings to give more strength to the magnetic attachments since the previous model was weak for the magnet distance. Also the light cover was updated since the previous have some problems for being too much flexibleFixed
Light cover
Added
(4) 3x6mm magnets to Wings inside part
Removed
(4) 10x3mm magnets from wings
1.0.0 (September 3, 2021)
Added
Release Version
Files List
| File | Print X times |
| cap.stl | 4 times |
| pin.stl | 12 times |
| wing_insert_left.stl | 4 times |
| wing_insert_right.stl | 4 times |
| wing_insert.stl | 4 times |
| wing_inside7x3.stl | 8 times |
| wing.stl | 3 times |
| wing_front_top.stl | 1 times |
Pre-supported files
The pre-supported files are intended as a quick guide to help you to print the files, the pre-supported files are named like slicer_pre.zip for example: lychee_pre.zip
An important note
Content License
Except where otherwise noted, the content by PolygonCollectibles is licensed under a Attribution-NonCommercial-NoDerivatives 4.0 International License.